xecuter 2.3 pro

How to fix X2.3b Pro cable for use with BLACK FCC adaptor
=========================================================

The problem with the cable that goes from the MOD to the FCC adaptor is that the connections on the socket of the adaptor are back-to-front!
To fix this use the following steps...

1. Gently prise off the back of the connector on the end of the cable.
2. Remove the cable from the connector and use sharp scissors to separate the cables (or a stanley knife, or wire cutters, your preference...but I find sharp scissors works BEST!)
3.Make sure the wires are cut quite FAR up and split them into 10 pairs, twisting each pair...

ORIGINAL ORDER
==============
1-2/3-4/5-6/7-8/9-10/11-12/13-14/15-16/17-18/19-20

AFTER TWISTING
==============
2-1/4-3/6-5/8-7/10-9/12-11/14-13/16-15/18-17/20-19

4. To help with re-fitting the plug, now do this...
5. Trim off the bits of the wire that were previously 'crimped' by the plug (this helps to avoid cross connections during re-fitting).
6. Tape the wires in position 'slightly' further up from the end where they will be re-fitted into the plug (this stops them from moving and cross connecting, which would be BAD!)
7. Slot the back onto the plug but DON'T crimp it together YET!
8. Slide the wires into the plug and 'gently' push down until they all line up from end to end (making sure they have remained twisted, and there are NO CROSS CONNECTIONS!)
9. Use a pair of pliers to re-crimp the plug together.
10. Re-connect the 'altered' cable to the BLACK FCC adaptor and TEST!
11. If the XBOX boots fine, well done! You fixed your cable! But...
12. If you get a F.R.A.G., try again, you messed up.


Sino se te da bien el ingles veria el traducirlo.

Saludos

voy a probar haber que pasa

ya hice lo que pone ahi y nada todo comprobao.
lo unico que hace la cabrona es encenderse y apagarse 3 veces tenga o no tenga chip eso es lo que me parece estraño

si la consola con el chip desactivado se resetea eso ya es mal rollo,algo hay mal, algo de estaño que se te haya caido,algun cable que haga puente,no se.

Revisalo todo por si acaso.

Saludos

en el momento de sacarle el chip me lo hizo un par de veces pero despues ya le paso pero ahora lo hace siempre, bueno voy a revisar todo haber si encuentro algo raro.
salu2