Te pongo como lo tengo yo, mis memos ya traen en el spd las especificaciones de 1000, aunke son de 800. Las pongo a 800 y cuando cambio el fsb a 333 cambian ellas solas a 1002. El VID de mi micro es de 1.325, mira el vid del tuyo y ponlo por ahi mas o menos.
AI Overclock tuner: MANUAL
CPU Ratio Setting: 9
FSB Frequency: 333
PCI-E Frequency: 100
FSB Strap to North Bridge: AUTO
DRAM Frequency: ddr2 1002
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: MANUAL
1st Information : 5-5-5-15 AUTO
2nd Information : AUTO
3rd Information : AUTO
DRAM Static Read Control: AUTO
DRAM Read Training: AUTO
MEM. OC Charger: AUTO
AI Clock Twister: LIGHT
AI Transaction booster: AUTO
CPU Voltage: 1.30
CPU GTL Voltage Reference (0/2): AUTO
CPU GTL Voltage Reference (1/3): AUTO
CPU PLL Voltage: AUTO
FSB Termination Voltage: AUTO
DRAM Voltage: 2.0
NB Voltage: AUTO
NB GTL Reference: AUTO
SBridge Voltage: AUTO
PCIE SATA Voltage: AUTO
Load Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : AUTO
NB Clock Skew : AUTO
CPU Margin Enhancement: Optimized
Advance CPU Settings
CPU Ratio Setting: 9
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
CPU TM Function: Enabled
Execute Disable Bit: Enabled
Esto es supersencillo sin romperte la cabeza, de aki en adelante depende de ti y tus ganas de investigar
S2
