Mas_configuraciones escribió:Here is my calibration image settings for the 42lh3000....
Expert 1
Backlight: 80
Contrast: 90
Brightness: 54
H Sharpness: 50
V Sharpness: 48
Color: 50
Tint: 0
Expert Control Submenu:
Dynamic Contrast: Off
Noise Reduction: Off
Gamma: Medium (uesd to use low with lower contrast but with this set up gives more realistic black levels, i think?)
Black Level: Low
colour balance: cool
Colour Gamut: Standard
Edge Enhancer: High
all other colour settings to 0
lumance 128
select Method 10 Point IRE
(advanced way to set white balance in 10 steps from dark to light. do not change if not sure what this does)
go down menu to ire and select 10 (current set at 100) and then below change red (1nit) to -1 move down to green(1nit) set to -2 and blue(1nit) to -6 then go up menu and select 20 in ire (you will notice values in selection boxes for red green and blue revert to 0) go down menu and add value red(4nit) 4/ green(4nit) 0/ blue(4nit) -1. repeat this proccess for all 10 values.
all values in the 10 steps to set are below...
10 IRE R-1 G-2 B-6
20 IRE R4 G0 B-1
30 IRE R9 G0 B-1
40 IRE R7 G0 B-1
50 IRE R13 G0 B-3
60 IRE R11 G0 B-6
70 IRE R14 G-1 B-7
80 IRE R13 G0 B-10
90 IRE R7 G0 B-15
100 IRE R3 G-1 B-12